It takes a lot of power to stop a moving trailer, especially when that trailer is hauling livestock, construction materials, industrial equipment or other heavy-duty cargo. Play it safe when you tow and give your trailer brakes the control they need with a CURT trailer brake controller and brake control harness.CURT quick plug brake control harnesses make the installation of your brake controller literally a snap. They are designed to allow your brake control to plug directly into your vehicle's power system using an original equipment connector. They are equipped with two plugs -- one that snaps into your vehicle's original equipment socket and the other that connects to any CURT brake controller, including Venturer, Discovery, Reflex and TriFlex. CURT quick plug harnesses install in less than 10 minutes to get you setup and on your way with time to spare. They include two feet of wire and a slit loom sleeve to keep wires well protected and contained.This brake control adapter harness is compatible with certain years of the Chevrolet Silverado and GMC Sierra. For a complete listing of vehicle compatibility, see the CURT application guide or visit curtmfg.com.
Manufacturer: Curt Manufacturing
Brand: Curt Manufacturing
CURT coupler locks are made to add security to your coupler when itâ€™s unattended. Locks are available in a variety of styles to suit your needs including barbell, narrow, multi-use, or adjustable. CURT coupler locks are designed for latch-type couplers and include two keys. Finishes available in chrome, brass, or zinc.
All vehicle specific brake control wiring harnesses are available in 1-Plug or 2-Plug styles. 1-Plug units are designed for brake controls manufactured with electrical wiring mounted on the back of the unit, otherwise known as a pigtail. Wiring harnesses must be spliced into the existing pigtail to allow the vehicle specific plug to be installed. 2-Plug units are designed for brake controls that have a wiring port built into the back of the unit. Simply plug the brake control end of the wiring harness into the back of the brake control and the vehicle end into the automobile's port. Brake controls that utilize the 2-plug style of wiring harness will be identified with the Plug and Play logo.
OPT7 7 Way Flat Blade to 4 Way Pin Adapter w/ Secure Tab - For Trailer Tow Hitch and Redline Tailgate LED - Weatherproof Construction
Brand: opt7 Lighting
The STRONGEST BEASTS ADAPT: Give your rig the ability to light up any trailer, 5th wheel, camper, UHAUL, or lighting accessory that uses a 4-pin connected instead of the standard 7-pin socket. The OPT7 7-pin to 4-pin adapter works with any factory OEM 7-pin plug from Chevrolet, Ford, Dodge, RAM, Toyota, or GMC. DRIVE ASSURED: Slides perfectly into any OEM 7-pin plug and stays on tight with resilient retainer fins. These fins work with your 7-pin dust cover to secure your adapter in place. No wiggle-room, no loose fittings. You can rely on your rear lights working 100% of the time. READY FOR ANY SITUATION: Whether it's a drive to the lake, freezing tundra, or a day at the sun, the rust resistant prongs and heavy duty construction can handle whatever you throw at it. FULLY COVERED by our free 1 Year warranty offered only by OPT7 Lighting.
Often times for vehicles too low or in an emergency situation the factory side jack points need to be utilized. Protect your frame rails when jacking up your car with these jack pads. Without proper support the thin rails bend and cause future use of them to be problematic, and even unsafe if the jack cannot secure to the jack point.